Create a fixed sewing station for your Ultrafeed^® Sewing Machine with this Industrial Sewing Table and Workhorse^® Servo Motor package. Give your Ultrafeed all the benefits of a modern servo motor, including slow speed power and quiet sewing, with this non-portable setup. This Workhorse Servo Motor package features 220-240 volt power (50 Hz) with 2-pin European plugs.

The Workhorse Servo Motor is a 550 watt, 3/4 horsepower motor designed for continuous use on industrial sewing machines. A brushless, energy-saving motor with a 12-coil design, the Workhorse provides high torque even from a complete stop. Fully adjustable speed settings let you control the top stitching speed. Set the maximum sewing range between 123-616 stitches per minute while never losing the ability to sew stitch by stitch. The Speed Reduction Pulley slows the motor down even more to give you incredible power and control when sewing at extremely slow speeds. The Workhorse motor paired with the Speed Reducer give you the ultimate in slow, stitch-by-stitch power for the most precise and controlled sewing.

The industrial sewing table with a custom tabletop is made from sturdy plywood with a melamine laminate surface. The tabletop is predrilled for easy assembly and the bottom is scored to make motor assembly and installation very easy. Included in the package is a threaded insert so you can install the Integrated Thread Stand directly to the tabletop. The tabletop surface measures 47-1/2 inches wide x 20 inches deep with a 14-3/4-inch x 7-1/8-inch cutout for the sewing machine.

The tabletop sits on our sturdy, metal K-Leg Table Frame with K-Leg Foot Treadle. Raise or lower the height of these legs from 28 to 34 inches for the most comfortable sewing position. An included oil tray helps to prevent oil drips. The legs measure 16-5/8 inches from front to back and the frame width is 38 inches.

To accommodate the Ultrafeed with a servo motor setup, you’ll need to remove the standard Ultrafeed motor. You must use the Power Plus^® Balance Wheel with the Workhorse Servo Motor. The motor is not designed for use with heavyweight balance wheels like the Monster^® II Balance Wheel. The use of this wheel could damage the motor and void the warranty. Additionally, due to the power the Workhorse Motor provides, do not set the sewing speed setting above 25.