Lift-The-DOT^® Hole Cutter is used to cut holes in fabric for installation of Lift-The-DOT^® eyelets. This hole cutter cuts the center hole and four small slits for the eyelet prongs in one easy step. A very easy-to-use tool and a real time-saver! There is a set screw for each of the four prongs. If a prong should break or become damaged, it's very easy to replace it using a hex wrench and needle-nose pliers. Four replacement cutting prongs are included with the tool. The tool is designed with two holes located on either side of the tool for the cut fabric to exit. These holes also help to align the tool consistently on your fabric.

Note: This hole cutter was designed for use with a resilient rubber cutting block and mallet. Improper use against too hard of a surface will possibly break one of the cutting appendages of the tool.