Swedish Snap #2 Wire to 7/16" is a jib hank forged from marine quality brass and fitted with a stainless steel spring that is used to secure jibs to the wire forestay. Bends into place and locks positively over the stay with a sliding piston that closes a hooked end. In the case of Swedish Snaps, installation requires the placement of a pressed spur grommet (usually a #2 size) just behind the luff reinforcement in the sail. The long arm of the snap is bent into place. This should be done gradually to prevent breakage--a leather mallet and many blows works well. Clear plastic inserts are used to reduce wear on the sail. Inserts sold seperately.
Swedish Snap #2 Wire to 7/16" Specification: (see Larger Image)
Be the first to know about promotions, new products, or great how-to advice.
Any rights not expressly granted herein are reserved. Sunbrella®, SurLast®, Firesist HUV® and Glen Raven®, Sunbrella® Plus, Sunbrella® Supreme, Sunbrella® Canvas, Sunbrella® Sling are registered Trademarks of Glen Raven, Inc. Lift-The-DOT®, Pull-The-DOT® and Common Sense® are registered Trademarks of Scovill Fasteners, Inc. YKK® is a registered Trademark of YKK CORPORATION in Japan and other countries/regions. Velcro® is a registered Trademark of Velcro Industries B.V. Sailrite®, Ultrafeed® and SnapRite® are registered Trademarks of Sailrite Enterprises, Inc.