The HandyPress® Twist-Lock Dual Snap Setter Kit (Button Back) is the easiest, fastest and most convenient way to install button back Twist-Lock fasteners. This four-piece snap setter kit sets the snap buttons using the HandyPress®. No more struggling with handheld punches and mallets. With just a pull of the HandyPress lever, you can install button back Twist-Lock fasteners in record time. This snap setter kit installs nickel-plated brass and stainless steel Twist-Lock fasteners, as well as double-high Twist-Lock fasteners.

Note: If you want the option of installing snap fastener eyelets as well as buttons, simply order the additional HandyPress® Two-Eyelet Cavity Snap Fastener Installation Die #126938.

To Use: 

Punching Holes:

First punch holes in your assembly for hardware installation. Use the HandyPress® Twist-Lock Dual Hole Punch Set (#126881, sold separately) or another hole-punching tool. For the Twist-Lock Dual Hole Punch Set: Thread the two punch tubes onto the adapter’s outer holes. Then, thread the adapter onto the HandyPress main vertical shaft. Set the workbench with cutting board so the back fence edge sets your desired fastener distance from the fabric edge. Follow the instructions in the HandyPress guidebook to set the tool for optimal results. 

Installing Fasteners:

Remove the Twist-Lock Dual Hole Punch Set. Thread the two Screw-In Installation Tools onto the 3-Hole Punch & Setter Adapter’s outer holes and thread onto the HandyPress main vertical shaft. Insert the Lower Die into the HandyPress base and tighten the Thumscrew for Lower Adapter. Place two Twist-Lock buttons in the Lower Die’s cavities. Raise or lower the upper shaft until the Screw-In Installation Tools are positioned to roll-form the rivets and are aligned with the button barrels. Place your hole-punched canvas and Twist-Lock fastener stud over the button barrels. Lower the HandyPress lever and set the fastener. 

Tip: Add the optional HandyPress® Ruler to aid in the consistency and efficiency of fastener hole spacing.

What’s Included:

• HandyPress® 3-Hole Punch & Setter Adapter (M8-1) #126810 — 1
• HandyPress® Two Button Cavity Snap Fastener Installation Die #126921 — 1
• HandyPress® Snap Fastener Screw-In Installation Tool #126809 — 2

Note: This snap setter kit was designed for the HandyPress. To see if it is compatible with your hand press check the dimensions tab and verify that it will attach to your press.