Loxx® Pull It Up Fastener Upper Head With Long Washer (Black Chrome-Plated Brass)
Loxx® Pull It Up Fastener Upper Head With Long Washer (Black Chrome-Plated Brass)
Loxx® Pull It Up Fastener Upper Head With Long Washer (Black Chrome-Plated Brass)
Loxx® Pull It Up Fastener Upper Head With Long Washer (Black Chrome-Plated Brass)
Loxx® Pull It Up Fastener Upper Head With Long Washer (Black Chrome-Plated Brass)
Loxx® Pull It Up Fastener Upper Head With Long Washer (Black Chrome-Plated Brass)

Loxx® Pull It Up Fastener Upper Head With Long Washer (Black Chrome-Plated Brass)

SKU: 121849
  • Exclusive
  • DIY Kit
  • New
  • Sale
  • Discontinued
$32.50 - $292.50
Shipping Restrictions
Not Returnable
Adding to cart… The item has been added

Product Details

The Loxx® Pull It Up Fastener Upper Head with Long Washer is the two-part upper section of the Loxx Fastener System. The Black Chrome finish of these fasteners gives them a sleek, modern, uniform look. This longer thread version is made to accommodate thicker fabric assemblies than the regular washer upper heads. Included are both the button and the clinch nut to make a complete upper section (you will receive them screwed together). This button is compatible with any lower section stud for cloth-to-cloth and cloth-to-surface applications. Loxx fasteners secure automatically and lock tight until the button is pulled. This positive engagement is created by a stainless steel spring inside the upper head that fits around the ball head of the stud. The result is a fastener that won’t accidentally come undone, but is still easy to operate.

These Loxx fasteners are made from brass and are ideal for hard environments. Their heavy-duty construction ensures they will perform snap after snap, even in difficult applications.

The long thread on this fastener works with fabrics 0.087 - 0.175 inch (2.2 - 4.445mm) thick or approximately 4-8 layers of fabric.

To Install: Cut a 3/8-inch hole at the installation point (we recommend a hole cutter – sold separately). Unscrew the washer from the head/stud if not already done. Place the threaded post of the head/stud through the hole and loosely screw the washer on from the opposite side. Holding the application, tighten the washer using the Locking Key or Locking Tool (each sold separately).