Loxx® Pull It Up Fastener Upper Head With Regular Washer (Nickel-Plated Brass)

The Loxx^® Pull It Up Fastener Upper Head with Regular Washer is the two-part upper section of the Loxx Fastener System. Included is both the button and the clinch nut to make a complete upper section (you will receive them screwed together). This button is compatible with any lower section stud for cloth-to-cloth and cloth-to-surface applications. Loxx fasteners secure automatically and lock tight until the button is pulled. This positive engagement is created by a stainless steel spring inside the upper head that fits around the ball head of the stud. The result is a fastener that won’t accidentally come undone but is still easy to operate.

Loxx fasteners are made from nickel-plated brass and are ideal for hard environments. Their heavy-duty construction ensures they will perform snap after snap, even in difficult applications.

This fastener will accommodate fabrics 0.065 - 0.125 inch (1.65 - 3.18mm) thick. This is approximately 3-6 layers of fabric.

To Install: Cut a 3/8-inch hole at the installation point (we recommend a hole cutter – sold separately). Unscrew the washer from the head/stud if not already done. Place the threaded post of the head/stud through the hole and loosely screw the washer on from the opposite side. Holding the application, tighten the washer using the Locking Key or Locking Tool (each sold separately).